
~
100
~
1x
H
OLDER
(water drain hose)
1x
30
B
OTTOM COVER
for the washer - dryer
(noise reduction)
1x
I
NSTRUCTION MANUAL
➢
Before initial operation, please check that all components are present and that
they are not visibly damaged.
2.2 Unpacking / Site
1.
Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-protection.
3.
Check that the appliance and the power cord are not damaged.
4.
Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise, the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or flammable
gases are stored.
5.
Protect the appliance from direct sunlight.
6.
Install the appliance in a dry and well-ventilated place. The room temperature
must
be higher than 0
0
C.
7.
The following minimum distances
must be
observed:
Back ↔ wal
l
mind. 100 mm
Sides ↔ wall
mind. 100 mm
8.
Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
9.
Do not install the appliance on a carpet / fitted carpet.
10.
Install the appliance on a level, dry and solid floor. Check the correct installation
with a bubble level.
30
Depending on model.