Pitney Bowes ADDRESSRIGHT DA950, Руководство оператора

Страница: 31 / 120

5
Basics
Setting
Up A Job
(continued) 3. Set the Feed Angle
The feed angle of the feed ramp depends on the type of
material you're running:
• Heavy material: adjust to a low angle
• Standard material: adjust to the center (45 degree
angle)
• Light material: adjust to a high angle
To make the adjustment:
A. Make sure the wire
form adjustment slide is
loosened.
B. Move the feed ramp up
or down as required.
C. Tighten the adjustment
slide to secure the ramp.
4. Set the Feed Ramp Length
Extend the feed ramp if you are running a longer piece of
material.
A. Loosen the feeder
locking knob.
B. Pull the feeder extension
out.
C. Tighten the feeder
locking knob to secure.
SV61183 Book.indb 3-5 SV61183 Book.indb 3-5 6/9/2004 9:16:48 AM 6/9/2004 9:16:48 AM