Pitney Bowes ADDRESSRIGHT DA950, Руководство оператора

Страница: 29 / 120

3
Basics
Setting the Proper Feed Gap
A. Unlatch and lift the
lock lever to its highest
position. This raises the
H-Block.
B. Place a sample piece
of material between the
separator fingers (the
lower section of the
H-Block) and the feed
roller.
C. Move the Lock Lever to the central position so that the
H-Block drops onto the material, then push the Lever
down to lock the H-Block in place.
Tips for Setting the Separators
• The blue hex nut has six (numbered) settings. When
one setting wears out, turn the nut to the next setting.
This will extend the life of the feed roller.
• If the material extends partially under the front H-Block
as in the example above, you could temporarily move
the material under both separator fingers of the front
H-Block and set this too. This may help with separation
and feeding of 'difficult' material.
• Filled Envelopes - Try setting a slightly wider separator
gap by adding one or two empty envelopes on top of the
filled envelope used to set the separator gap.
• Postcards - Try setting a slightly wider separator gap by
adding one sheet of standard copy paper on top of the
postcard used to set the separator gap.
Setting
Up A Job
(continued)
SV61183 Book.indb 3-3 SV61183 Book.indb 3-3 6/9/2004 9:16:47 AM 6/9/2004 9:16:47 AM