Piper PA-34-200T Seneca II, Руководство по обслуживанию

Страница: 132 / 869

PIPER SENECA II SERVICE MANUAL
TABLE III-I. INSPECTION REPORT
(cont.)
Inspection
NATURE OF INSPECTION Interval (Hrs)
50 100
E. FUSELAGE AND EMPENNAGE GROUP
1. Remove inspection plates and panels .................................................................... O
2. Inspect battery box and cables
Flush area as required and fill battery per Battery, Section II................................
O O
3. Check fluid level in brake reservoir. (Fill as required.) ........................................ O O
4. Inspect electronics installations for condition and security ................................... O
5. Inspect antennas, mounts, and wiring for damage and security ............................ O
6. Inspect skins, bulkheads, frames, and stringers for damage, irregularities,
or structural defects (i.e. - skin cracks, distortion, dents, corrosion,
and loose or missing rivets)....................................................................................
O
7. For airplanes used for training, equipped with Prestolite pumps: Inspect
hydraulic pump motor brushes. (See Note 16.) .....................................................
O
8. Inspect aft wing attach fittings per paragraph 4-33a.............................................. O
9. Check hydraulic pump fluid level. (Fill as required.) ............................................ O O
10. Inspect hydraulic lines for damage and leaks ........................................................ O
11. Check air conditioning system for refrigerant leaks .............................................. O
12. Check refrigerant level in sight gauge of receiver-dehydrator. (Refer to
Section XIV.).......................................................................................................... O O
13. Inspect air conditioner condenser air scoop for condition and rigging.................. O O
14. Inspect cabin heater. (See AD 2004-21-05.) .......................................................... O O
15. Check fuel lines, valves and gauges for damage and operation............................. O
16. Check security of all lines...................................................................................... O
17. Inspect vertical fin for surface damage or irregularities (i.e. - skin cracks,
distortion, dents, corrosion, and excessive paint build up); structural defects
(i.e. - loose or missing rivets); misrigging or structural imbalance; hinge damage,
excessive wear, freedom of movement and proper lubrication; and attachment
points for missing or worn hardware. ....................................................................
O
18. Inspect vertical fin attachments for condition and security ................................... O
19. Inspect rudder for surface damage or irregularities (i.e. - skin cracks,
distortion, dents, corrosion, and excessive paint build up); structural defects
(i.e. - loose or missing rivets); misrigging or structural imbalance; hinge damage,
excessive wear, freedom of movement and proper lubrication; and attachment
points for missing or worn hardware. ....................................................................
O
20. Inspect rudder hinges, horn and attachments for damage and
operation ................................................................................................................ O
21. Inspect rudder tab hinge bolts for excess wear. (Replace as required.)
(See Note 14.) ........................................................................................................ O
22. Inspect rudder trim mechanism. (See Note 14.) .................................................... O
23. Inspect stabilator and tab for surface damage or irregularities (i.e. - skin cracks,
distortion, dents, corrosion, and excessive paint build up); structural defects
(i.e. - loose or missing rivets); misrigging or structural imbalance; hinge
damage, excessive wear, freedom of movement and proper lubrication;
and attachment points for missing or worn hardware ............................................
O
01/01/09 III - INSPECTION
1C49