Piper PA-34-200T Seneca II, Руководство по обслуживанию

Страница: 75 / 869

PIPER SENECA II SERVICE MANUAL
2-43. SERVICING HYDRAULIC PUMP/RESERVOIR.
The fluid level of the reservoir of the combination pump and reservoir should be checked every 50 hours
by viewing the fluid through the filler plug hole in the hydraulic pump. Access to the pump is through
the panel at the right forward side of the nose baggage compartment.
To check fluid level, remove the filter plug located on the forward side of the pump and ascertain that
fluid is visible up to the bottom of the filler plug hole. Should fluid be below the hole, add fluid, MIL-H-
5606, through the filler hole until full. Reinstall the filler plug and tighten.
NOTE: A small vent hole is located under the vent screw head. Retain 1/64 inch clearance between the
screw head and small vent hole.
2-44. BATTERY.
2-45. SERVICING BATTERY.
Servicing of the battery which is located under the floor panel of the forward baggage compartment,
involves adding distilled water to maintain electrolyte even with the horizontal baffles, checking cable
connections, and checking for any spilled electrolyte that would lead to corrosion. A check for proper
fluid level and presence of corrosion should be conducted at intervals of 50 hours or 30 days, whichever
comes first. When corrosion is found, at each 100 hour inspection or every 90 days, the battery should be
removed from the box and the battery and box should be cleaned. Removal, cleaning, and charging
instructions may be found in Section XI of this manual.
2-46. CLEANING.
2-47. CLEANING ENGINE COMPARTMENTS.
Before cleaning the engine compartments, place a strip of tape on the magneto vents to prevent any
solvent from entering these units.
a. Place a pan under the engines to catch waste.
CAUTION: DO NOT SPRAY SOLVENT INTO THE ALTERNATOR, STARTER, AIR INTAKE,
ALTERNATE AIR INLETS AND PRESSURE PUMP DRIVE AREA.
b. With the engine cowlings removed, spray or brush the engines with solvent or a mixture of solvent
and degreaser as desired. It may be necessary to brush areas that were sprayed, where heavy grease
and dirt deposits have collected in order to clean them.
c. Allow the solvent to remain on the engine from five to 10 minutes; then rinse the engine clean with
additional solvent and allow to dry.
CAUTION: DO NOT OPERATE ENGINES UNTIL EXCESS SOLVENT HAS EVAPORATED
OR OTHERWISE BEEN REMOVED.
d. Remove the protective covers from magnetos.
e. Lubricate controls, bearing surfaces, etc., per Lubrication Chart.
II - HANDLING AND SERVICING 01/01/09
1B20B