Piper PA-34-200T Seneca II, Руководство по обслуживанию

Страница: 129 / 869

PIPER SENECA II SERVICE MANUAL
TABLE III-I. INSPECTION REPORT
(cont.)
Inspection
NATURE OF INSPECTION Interval (Hrs)
L R 50 100
B. ENGINE GROUP (Cont.)
7. Inspect oil lines and fittings for leaks, security, chafing,
dents, & cracks. (See Note 26.)............................................................... O
O O O
8. Clean and inspect oil radiator cooling fins.............................................. O O O
9. Fill engine with oil per information on cowling
or in Lubrication Chart, Section II .......................................................... O
O O
CAUTION: USE CAUTION NOT TO CONTAMINATE PRESSURE
PUMP WITH CLEANING FLUID.
10. Clean engine with approved solvents...................................................... O O O
11. Check condition of spark plugs. (Clean and adjust gap as required,
see Note 9.) ............................................................................................. O O O
NOTE: If fouling of spark plugs is apparent, rotate bottom plugs to upper
plugs.
12. Check cylinder compression. (See Note 7.) ............................................ O O O
13. Inspect ignition harness and insulators for security of mounting,
tight connections, high tension leakage and continuity.
(See Notes 9 and 23.) .............................................................................. O
O O O
14. Check magneto points for proper clearance. (Maintain
clearance at 0.018 +006.) (See Note 9.) .................................................. O O O
15. Inspect magnetos. (See Note 18.)............................................................ O O O
16. Check breaker felts for proper lubrication .............................................. O O O
17. Check magnetos to engine timing ........................................................... O O O
18. Remove induction air filter and tap gently to remove dirt particles.
(Replace as required.) ............................................................................. O O O O
19. Clean injector nozzles as required. (Clean with acetone only.) .............. O O O O
20. Replace the pressure system inlet air filter (i.e., central air filter,
gyro filter, etc.) element. (See Note 13.) ................................................. O O O
21. Remove induction air box valve and inspect for evidence
of excessive wear or cracks. Replace defective parts.............................. O O O
22. Inspect fuel injector attachments for loose hardware.............................. O O O
23. Inspect engine primer system for operation, security, and leaks............. O O O
24. Check intake seals for leaks and clamps for tightness ............................ O O O
25. Inspect all air inlet duct hoses. (Replace as required.)............................ O O O
26. Inspect condition of flexible fuel lines.................................................... O O O
27. Inspect fuel system for leaks. (See Note 17.).......................................... O O O
28. Inspect engine-driven and electric fuel pumps for condition
and operation. Replace as required. (See Note 12.) ................................ O O O
29. Inspect dry-air pressure pumps for condition and operation,
and security of lines. (See paragraph 10-16a.)........................................ O O O
III - INSPECTION 01/01/09
1C46