Piper Aircraft Corporation CHEYENNE PA-31T, Руководство пользователя

Страница: 29 / 68

16 Inspect gas generator case for cracks, distortion and evidence of overheating (P&W Maintenance
Manual).
17 Inspect exit exhaust ducts and stacks for cracks and distortion (P&W Maintenance Manual).
18 Inspect propeller shaft for oil leaks.
19 Inspect magnetic chip detector (P&W Maintenance Manual).
20. Remove, drain and clean fuel filter bowl and element (drain and clean at least every ninety (90)
days).
21. Inspect all flexible lines (fuel, hydraulic and oil), and replace on condition (Refer to Piper Service
Manual, Section III).
22. Inspect fuel system for leaks.
23. Check submerged fuel pumps for operation.
24. Replace hydraulic filter element (check element for contamination) (Piper Service Manual,
Section Vl).
25. Inspect hydraulic pump and gaskets for leaks (Piper Service Manual, Section Vl).
26. Inspect all engine fire seals for cracks and security (Piper Service Manual, Section Vlll).
27. Inspect torque pressure transmitter for security and wiring (P&W Maintenance Manual).
28. Check fire extinguisher pressure in accordance with Piper Service Manual, Section XIV.
29. Inspect breather tube for obstruction and security (P&W Maintenance Manual).
30. Check for proper oil level and filler locking cap for security.
31. Inspect engine mounts for cracks and loose mount bolts (Piper Service Manual, Section Vlll).
32. Inspect P3 air filter for foreign material (clean as required) (P&W Maintenance Manual) (Refer to
Special Inspection, 1000 hour).
33. Inspect rubber engine mounts for deterioration (Refer to Special Inspection, 400 hour).
34. Inspect firewall for cracks and stress.
35. Inspect firewall seals.
36. Inspect condition of starter-generator (Refer to Special Inspection, 300 hour).
37. Inspect security of air conditioner compressor mount. (Refer to Special Inspection, 300 hour.)
38. Lubricate Power Plant per Piper Service Manual (Section II) and per P&W Maintenance Manua1.
39. Inspect compressor drive belt condition and tension per Piper Service Manual, Section Xlll. (Refer
to Special Inspection, 300 hour.)
40. Inspect compressor clutch for security and wiring. (Refer to Special Inspection, 300 hour.)
41. Inspect tachometer generator for security and wiring.
42. Install engine cowl.
1. Remove and inspect spinner and back plate for security.
2. Inspect blades for nicks and cracks.
3. Check for excessive grease and oil leaks.
4. Check condition of propeller deicer boots.
Interim Revision: October 26, 1994 Page 29
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
❐
SERIAL NUMBER REGISTRATION NUMBER ENGINE SERIAL NO.
Left:
Right:
PROPELLER SERIAL NO.
Left:
Right:
CHEYENNE
PA-31T AND 31T1
PROGRESSIVE INSPECTION
50 HOUR EVENTS
EVENT #2 (cont.)
LEFT PROPELLER, ROUTINE