Pionetics LINX 140T, Руководство пользователя, Страница: 16 / 23

Consumer Install 12.16.2016 16
Whenever installing or replacing the LINX TDS cartridges and sediment/carbon filters, carefully check for leaks from inadequate
o-ring seals. At the end of service, remove the top two lid covers and check for water in the lid driver crevices, and examine the
filter housing for slow leaks. See sections 4.3 and 4.4 for more details.
System Operation
The two LINX TDS cartridges operate in parallel during normal water production to provide >85% TDS reduction. When the
service volume has been delivered (3 gallons on the low TDS feed setting and 1.5 gallons on the high setting) a 34-minute
regeneration takes place. You may hear water discharging to the drain during regeneration.
After regeneration a “clicking” noise will be heard for 20 seconds during which time the LINX 140 system is cleaning its valves.
Note: While drinking water is always available, the LINX systems are designed for intermittent, not continuous, use. To
obtain the specified ≥85% TDS reduction, the systems must be configured as described in the Specification section. To
maintain the 3-year Warranty, the average daily usage must be <25gallons.
Indicator Lights
Beneath the Dial-a-Taste control knob is a green light indicating that the unit is powered and functioning. The four other
indicator lights, labeled A, B, C and D (see image below) are used to indicate system status as shown in the following table.
When the systems are producing water, blue lights A and C flash indicating both cells are delivering water. A single red flashing
light indicates that regeneration of that cell is in progress. The indicator lights also signal when the blue safety lid covers are not
installed correctly and when service is required (see the table below for the lights observed in each case). For the four “alarms” at
the bottom of the table, repowering will reset the system; if the alarm re-occurs, call Technical Support at 866-611-8624.