Pionetics LINX 140T, Руководство пользователя, Страница: 12 / 23

Consumer Install 12.16.2016 12
9. Insert the filter housings with the filters placed into their
appropriate place in the manifold (they are labeled). There
is a place for an optional ultra violet light (UV) which
should remain empty. Be sure that the threads are aligned
so that you get a good seal.
(See Figure 8 to note where
the respective housing units get installed and to see the
unit installed.)
10.
Locate the two LINX TDS cartridges
(see Figure 9)
. Then locate
and lift out the two Lid Drivers from the exposed LINX unit
(see
Figure 10 to identify these parts and location.)
11.
Slide the “mushroom top” on each TDS cartridge through the slot on
each of the lid drivers
(see Figure 11)
. Drop the cartridges back into
the top of the LINX unit and tighten each Lid Driver using the LINX
Wrench provided in your kit
(see Figure 12)
. NOTE that the center
spine on the lid driver must line up front to back to be fully engaged
(see Figure 13)
.
Figure 8
Figure 9
Figure 11
Figure 12
Figure 10
Figure 13