6
EN
Getting Star
ted
For the sake of safety, the device will not charge when
•
outside the temperature range of 0 °C to 45 °C. When the
devices internal temperature is too high, full charge may not
be achieved. In this case, turn off the device, allow time to
cool down and recharge.
Connect the provided USB cable directly to a USB port of
•
your PC. If the device is connected via a USB hub, it may
not charge to full capacity. Make sure that the USB output of
your PC accepts 5V/500mA.
Do not unplug the USB cable, shut down the PC or use
•
sleep mode while the device is transferring data as it may
corrupt the data in the device.
4
Unplug the USB cable from the USB port.
Once data transfer is complete and the battery is fully
charged, disconnect the USB cable from the PC first,
then from the device.
5
Close the USB connector cover.
To ensure water resistant performance, firmly close the
USB cover.
Checking the Battery Level
You can check the battery level with the battery icon on the
status bar of the home screen and the menu screen.
Battery icon
When the battery is running low on power, a warning screen
•
will appear “Battery Level Decreasing.” If not recharged, the
device will shut down automatically.
You can also check the remaining battery charge using the
•
[System] item of "Cyclocomputer Settings".
Ü
System (page 45)
Operating Time Indicator
A fully charged battery allows the device to be used for the
amount of time shown below.
A fully charged battery can run for approximately 12
•
hours.
Operating time may vary depending on the operating
•
conditions.
If the operating time is abnormally short, the battery may
•
need to be replaced. For details, please visit our website.
The device is not charged at the time of purchase.
Charge the device with the provided USB cable before
using it.
Charging the Device
1
Open the USB connector cover.
2
Connect the provided USB cable to the USB
connector of the device.
3
Turn your PC on and connect the USB cable to
an open USB port on your PC.
The device starts charging.
The device is turned off
•
To power up
•
Press the [START/STOP] button for more than 2 seconds
to turn on the device for use.
Press the [START/STOP] button for more than 2 seconds
again to turn off the device. Charging time is shorter if the
device is turned off.
Charging icon
: Charging
: Fully charged
It takes about 4 hours to charge fully (Power off or normal
•
charging).
When the device is turned off, the screen turns dark after 5
•
seconds. To check the battery level, touch the touch panel
or press the [START/STOP] button.
Charging
