117
Techno Tidbits & Problem-solving
EXPER
T
• There is no problem. The indicator won't
light when the track is not a compressed
digital source.
• Choose DIGITAL or AUTO with the signal
select button (p.51).
• This is not a malfunction. Check the
manufacturer information for the source.
• Switch the LISTENING CH SELECT to
7.1 and switch to the THX Surround EX or
Standard TX listening mode (p.49-50).
• Switch the LISTENING CH SELECT to
AUTO and switch to the HOME THX or
STANDARD listening mode (p.49-50).
• Switch the LISTENING CH SELECT to
7.1 and switch to the THX Surround EX or
Standard TX listening mode (p.49-50).
• This is not a malfunction. See the
player's manual for more details.
• Switch to STANDARD mode (p.49-50).
• Turn it/them off.
• The source has been downmixed to 48
kHz.
• Replace the batteries (p.8).
• Operate within 7 m, 30° of the remote
sensor on the front panel.
• Remove the obstacle or operate from
another position.
• Avoid exposing the remote sensor on the
front panel to direct light.
• Connect cord to the correct jack (p.84).
• Disconnect the IR Receiver from the rear
panel, and set to the other IR Receiver type
using the remote control (p.81).
• Turn Locking the settings off (p.72).
• Set the lock switch to USE (p.9).
• Input the correct preset code (p.69).
• Reset the proper system settings (p.69).
A compressed digital source
is being played, but the
digital format indicators
don't light up.
During playback of a
compressed digital source,
the
2
PRO LOGIC or NEO:6
indicators show in the
display.
During playback of a
Surround EX or DTS ES
source on the AUTO setting,
the EX and ES indicators
won't light.
During playback of a
Surround EX or DTS ES
source on the AUTO setting,
the EX and ES indicators
light, but the signal is not
properly processed.
During playback of a DVD
audio source, the player
shows a transfer rate of
96kHz, but the receiver does
not.
During playback of a DTS 96/
24 source, the display doesn't
show 96kHz.
Remote control
Cannot be remote controlled.
Other components can't be
operated with the system
remote.
Problem
Cause
Remedy
• Although it's a non-PCM digital source
there is a possibility the present track is not
the proper format (5.1, 6.1, or 7.1 channel).
• The digital signal is not being sent with
the source.
• The audio is in two channel format.
• It has already been Dolby surround
encoded.
• The source may be 6.1 playback
compatible, but there is no signal from the
source to indicate this.
• The listening mode is set incorrectly for
the source.
• The multi channel connections are
analog, so there is no digital transfer.
• The receiver may be on a different mode
than STANDARD.
• One of the DIGITAL NR, MIDNIGHT and
LOUDNESS features are switched on.
• The setting for speakers other than the
surround back is set to NO.
• The remote control batteries have worn
out.
• Too far away or bad angle of operation.
• There is an obstacle between the
receiver and the remote control.
• Strong light such as fluorescent light is
shining onto the unit's remote control signal
light-receiving window.
• A cord is connected to the CONTROL IN
terminal on this unit.
• The IR -Receiver type is mismatched
with the setting.
• Locking the settings on the remote
control is turned on.
• The lock switch on the remote control is
set to LOCK.
• The preset code settings are wrong.
• The battery wore out and the system
Содержание Elite VSX-49TX
Страница 3: ...3 ...
