Pioneer DV-757AI, Руководство по эксплуатации

Страница: 82 / 172

Additional Information 09
82
En
Problem
The analog audio is OK, but
there appears to be no
optical/coaxial digital audio
signal.
Noticeable difference in DVD
and CD volume.
Cannot play multi-channel
audio
Cannot listen to high-sampling
rate audio through the
optical/coaxial digital output.
Cannot output 192kHz or
176.4kHz digital audio from
optical/coaxial output.
Cannot output 96kHz or
88.2kHz digital audio from
optical/coaxial output.
No DTS audio output from
optical/coaxial output.
Cause / Remedy
• Make sure that the Digital Out setting is set to On ( page 56 ).
• Check that the Dolby Digital, DTS and MPEG out settings
(
pages 56-58 ) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• SACDs and some DVD-Audio discs do not output digital audio.
Listen through the player’s analog audio outputs.
• This is due to differences in the audio format and is not a
malfunction.
•Make sure that Audio Output Mode is set to 5.1 Channel
( page 67 ).
•Check that the Dolby Digital, DTS and MPEG Out settings
(
pages 56–58 ) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital
audio. Listen through the player’s analog outputs.
• Check that the settings in the
Speaker Installation screen are
correct ( page 67 ).
• Check the audio options available from the disc menu.
• Make sure that Linear PCM Out is set to Down Sample Off
( page 57 ).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to
Down Sample Off , the player
automatically outputs the audio at 48 kHz. This is not a malfunc-
tion.
• The player does not output digital audio from the optical/
coaxial jacks at these sampling rates. The digital output is
automatically downsampled.
• Check that Linear PCM Out is set to Down Sample Off
( page 57 ).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automati-
cally downsampled.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set
DTS Out to DTS > PCM .
If you do not do this, noise will be output when you play a DTS
disc.
• If this unit is connected to a DTS-compatible amplifier or
decoder using a digital audio cable, check the amplifier settings,
and that the cable is properly connected.