32
DDJ-RB
1
2
3
4
A
B
C
D
E
F
1
2
3
4
NG(Heavy)
[AUTO] LED is turned on if the measurement is OK
[TAP] LED is turned on if the measurement is failed.
[AUTO] LED is turned on if the measurement is OK
[TAP] LED is turned on if the measurement is failed.
Indicates the number of measurement
sessions executed (up to 4 sessions).
If the maximum speed does not reach 7.0 times normal speed,
the all PAD LEDs of the rotated side will blink.
If the maximum speed does not reach 7.0 times normal speed,
the all PAD LEDs of the rotated side will blink.
2
-1: Measurement mode of the load of JOG dial
This mode is to measure the load of JOG dial. When the measurement mode starts, FX1 ON of the left DECK will light up.
When the JOG dial is rotated swiftly, measurement for the top speed and the time required for slowdown will begin.
When the rotation speed of the Jog dial exceeds 7 times normal speed, the time required for slowdown will be assessed
whether it is in the range or not. The result will be displayed on LED.
Top speed
: when normal speed is defined as one rotation in 1.8 sec
Time required for slowdown
: Time required for the jog dial to decrease its rotation speed
Operation procedures
1. Spin the Jog dial swiftly.
To start measurement, the maximum Jog rotation speed must be 7 times normal speed or higher.
If the maximum speed does not reach 7.0 times normal speed, PAD LEDs (8 PADs)will blink several times.
2. The number of sessions will be displayed up to four sessions on LED as follows.
The end of 1st session
HOT CUE lighting
The end of 2nd session
PAD FX1 lighting
The end of 3rd session
SLICER lighting
The end of 4th session
SAMPLER lighting
After the end of 4th session
remain unchaged
3. The result will be displayed on LED.
OK
[AUTO]
LED
is
turned
on
NG (failed)
[TAP] LED is turned on.
4. When the measurement is failed, PAD LED indicates as follows.
NG
(Heavy)
PAD[5]
lightin
NG
(Light)
PAD[8]
lighting
The number of measurement sessions executed is displayed up to 4 sessions.
The measurement can be continued 5 sessions and more, however the number of sessions will not be displayed.
When the session ended, an average is taken each time and the result will be displayed on LED.
Regulation value is 100
The measurement result
You can check the measurement result using "JOG_Checker.exe".
NG(Light)
NG(Heavy)
NG(Light)
40 [msec]. (The specification is subject to change.)
Indicates the number of measurement
sessions executed (up to 4 sessions).
