36
DDJ-RB
1
2
3
4
A
B
C
D
E
F
1
2
3
4
[1] Each PCB Assemblies
• Exterior Section
(1) Remove the all knobs.
(2) Remove the 3 Silider knobs 2, 3 Slider knobs 1,
and 3 Stoppers/SLD.
(See
below.)
1
2
The reference of the direction
Disassembly
1
Find the side on which the line reaches
the
bottom.
4
Remove the Slider knob 1.
3
Remove the Slider knob 2.
2
Insert a pair of tweezers etc. beneath
the line then push the Slider knob 2 upward.
To protect the panel from being
scratched, use protective material.
• Disassembly of the slider knob
The new slider knob adopted by this product is designed so that it is not pulled out easily.
Therefore, the method for removing the slider knob is different from the conventional method; it can only be pulled out after
Slider knob 2 is removed.
Protective material
Tweezers
Slider knob 2
Slider knob 1
Slider knob 2
*: During reassembly, fully push
down Slider knob 2 until it is
dented into Slider knob 1.
5
Remove the Stopper/SLD.
Stopper/SLD
Side on which
the line reaches the bottom
Stopper
(right direction)
Stopper
(rear direction)
