Pinnacle Systems miroVIDEO DV200, Руководство пользователя

Страница: 91 / 114

User´s Guide
85
program that guarantees loss less resampling. After this resampling is
performed, you can use this file in Premiere.
An insert of a Premiere project to a DV tape that contains data should use
the same audio sampling rate to avoid sound glitches.
Device control fails during tape scan or batch capture.
DV Tools uses time code information that is stored on you DV tapes. Please
activate this time code function (TC) for you DV device. Make sure that the
clock of your device is set and functioning.
We recommend stripping the DV tapes before shooting real footage. You
can ”pre-format” the tape putting the camera into recording mode until the
tape is full. Leave the lens covered. The tape will then contain continuous
time code information and will work properly.
The video played off of my DV tape is showing horizontal shifts in large
bands.
Cause: The effect of large horizontal shifts in the video played back from a
DV tape is most likely the result of dirty video heads in the camcorder.
Solution: Please refer to your DV camcorder owner's manual and follow the
guidelines printed there for the properly cleaning the record heads of the
camcorder.
The playback to the computer monitor is jerky, audio- or video-frames
are dropped.
The playback to the computer monitor may exhibit "jerky" motion using
DVTools, Premiere or Media Player for playback. Check the miroVIDEO
DV200 Configuration program for the best settings. It is recommended that
you enable primary and overlay surface support for Direct Draw settings, if
your display adapter supports these settings. This will take full advantage of
the graphics adapter capabilities. You may need to test different settings and
choose the setting best suited for your system. Please refer to the Installation
section of this manual for more detailed information.