Pinion C-Line C1.12, Руководство пользователя

Страница: 25 / 36

InstallatIon work
25
adjustIng ChaIn tensIon (PInIon ChaIn tensIoner)
if your chain frequently hits the chain stay on your bicycle frame while you are riding,
it may be necessary to increase the chain tension.
if the chain or cranks continue to rotate although the rear wheel freewheel is operating correctly, or if
the chain tensioner rattles, it may be necessary to reduce the chain tension.
before proceeding with the following actions, make sure that your chain is the correct
length – see
InstallIng PInIon ChaIn tensIoner
, page 24.
Î
Î
remove the chain and take it off the chain ring and sprocket.
Î Î
disconnect the spring leg (1) at the tension mechanism (2) .
Î
Î
rotate the tension mechanism forward.
Î
Î
the screw (3) of the spring shaft is accessible.
4 N·m (35 lbf·in) max.
29
1
5
6
4 N·m (35 lbf·in) max.
28
1
2
2
3
3
Î Î
unscrew the screw (3) of the spring shaft (4) .
Î
Î
pull the spring shaft out of the baseplate (6) .
Î Î
move the spring end pin (5) counterclockwise (+).
•
•
the chain tension is increased.
or:
Î Î
move the spring end pin (5) clockwise (–).
•
•
the chain tension is reduced.
Î Î
insert the spring shaft into the baseplate (6) .
Î Î
screw in the screw (3) of the spring shaft (4) and tighten with a tightening torque of 4 n·m
(35 lbf·in).
Î Î
position the chain on the chain ring and sprocket.
Î Î
attach spring leg (1) to tension mechanism (2) .
Î Î
check the setting.
4