Pinion C-Line C1.12, Руководство пользователя

Страница: 22 / 36

InstallatIon work
22
0,4 N·m (4 lbf·in) max.
1,5 mm
22
damage to the shifting cable liner.
Î –
carefully guide shifting cables through the shifting cable liners.
Î –
remove shifting cable liners first if necessary and guide back in together with the shifting cable.
Î Î
switch rotary shifter to position 01.
Î Î
insert the left end of the shifting cable (output 1.) through rear adjusting screw (12) – as seen in
riding direction – shifting cable liner (13) , shifting cable guide (14) and shifting cable clamp (15) .
Î
Î
keep the left end of the shifting cable under tension.
Î Î
make sure that the ends of the shifting cable outer sleeve are firmly in the stops on the adjusting
screw and cable box.
Î Î
tighten the two clamp screws alternately with a tightening torque of 0.4 n·m (4 lbf·in).
Î Î
cut the left end of the shifting cable as close as possible behind the cable clamp with a small,
sharp wire cutter.
pull the cable clamp out of its seat somewhat. then, it will be easier to cut off the end
of the shifting cable.
Following that, make sure that the cable clamp is once again located in its seat up to the stop.
Î
Î
C1.12
rotate rotary shifter clockwise (01–02–03– … –12) to position 12.
15
12
13
14
0,4 N·m (4 lbf·in) max.
1,5 mm
23
19
or:
Î
Î
C1.9
XR
rotate rotary shifter clockwise (01–02–03– … –09) to position 09.
or:
Î Î
C1.6
rotate rotary shifter clockwise (01–02–03– … –06) to position 06.
Î Î
insert the right end of the shifting cable (output 2.) through front adjusting screw
(16)
– as
seen in riding direction – shifting cable liner (17) , shifting cable guide (18) and shifting cable
clamp (19) .
Î Î
keep the right end of the shifting cable under tension.
Î
Î
make sure that the ends of the shifting cable outer sleeve are firmly in the stops on the adjusting
screw and cable box.
Î Î
tighten the two clamp screws alternately with a tightening torque of 0.4 n·m (4 lbf·in).
Î Î
cut the right end of the shifting cable as close as possible behind the cable clamp with a small,
sharp wire cutter.
16
17
18