Pinguely-Haulotte HA20PX, Руководство по ремонту

Страница: 72 / 282

Repair manual
66
12.6 - OPERATIONS.
12.6.1 -Summary table
REMINDER :All these intervals must be reduced if working in difficult
conditions (refer to the After-Sales Department if necessary).
PERIODICITES OPERATIONS REPERES
Each day or before
each putting into
service • Check the following levels:
- engine oil
- hydraulic oil
- diesel
- electric batteries
• Check the cleanness of the following:
- gasoil pre-filter
- engine air filter
- machine (check in particular the watertightness of the connectors
and hoses), take this opportunity to check the condition of the tyres,
cables and all accessories and equipment.
• Check the clogging of the hydraulic oil filter: an indicator indicates
clogging; change the cartridge when the mark appears.
1
2
3
4
5
6
7
Every 50 hours • Engine: see engine manufacturer's manual
• Check the level of the drive wheel reducers (see Chapter 5.3.2.2, page
49)
• Grease:
- the wheel pivot pins: 8 points
- steering axle, centre pivot and slot pin: 10 points
- slewing ring : bearing (2 points)
- slewing ring : teeth (brush)
- pendular hinge pin: 2 points
- pendular link piece hinge pin: 4 points
- boom bottom shaft: 1 point
• Clean gasoil pre-filter
8
9
10
11
12
13
14
15
31
16
After the first 50 hours • Change the hydraulic filter's cartridge (see 250 hour interval)
• Drain the drive wheel reducers (see 500 hour interval)
- 2 points for 4x2 model - 4 points for 4x4 model
• Check the tightness of the slewing ring screws (torque: 27 daNm)
17
18
19
Every 250 hours • Engine: see engine manufacturer's manual
• Grease the telescope's friction parts (spatula)
• Check the condition of the telescopic cylinder friction pads
• Check the tightness of the wheel nuts (torque: 32 daNm)
• Change the hydraulic filter's cartridge 20
21
22
23
Every 500 hours • Engine: see engine manufacturer's manual
• Drain the wheel reducers. Fill up again: capacity : 4 x 1.4 l
• Ring screw : check tightness and tighten if necessary (torque: 27
daNm)
24
25
26
OPTION : every 500
hours or every 6
months • Empty the hydraulic oil tank completely if you have the «organic hy-
draulic oil» option
27
Every 1000 hours or
every year • Engine: see engine manufacturer's manual
• Drain the hydraulic oil reservoir
27
Every 2000 hours • Engine: see engine manufacturer's manual
• Drain the hydraulic oil complete circuit and reservoir
• Drain and clean the diesel tank
• Grease: rotation reducer: 1 point
28
29
30