_______________________________________________________________________________
5 of 19
Navod obsl OR 50(F)_2006-08-01_EN.doc
0.1 Safety
Provisions
The machine design complies with the technical status and the approved safety and
technical rules. In spite of this, the user’s or the third persons’ health can be endangered
and/or the machine or other tangible goods may be unfavorably influenced during the
operation of the machine.
In order to prevent such hazards, it is unconditionally necessary to observe the safety
instructions in this instruction manual.
These safety instructions must be read and understood by the respective persons before
the machine has been put into operation.
Failure to observe these instructions may cause serious health and property damage!
The safety instructions are marked in this instruction manual with safety symbols / danger
spot signs.
Danger spot
Proceed with maximum caution
Dangerous voltage
Use goggles
Use protective gloves when handling the
saw band
0.2
Requirements Concerning Operators
The machine may only be operated by persons instructed in safety at work and
appropriately trained.
The machine may only be operated if in perfect condition with respect to technical safety.
The user is obliged to check the machine for visually detectable damages and failures at
least once per shift. Any changes, failures and damages of protective covers, changes of
the machine behavior endangering the safety should be immediately reported to the
supervisor. Wait for the decision about the repair and the putting into operation.
No safety devices may be removed, moved, put out of operation or changed during the
machine operation.
If any safety device has to be removed during operation or maintenance, secure the main
switch in the „OFF“ position by a padlock or disconnect the machine from the mains.