12.3. HVP Vertical Vice for Bundle Cutting
The HVP vertical vice facilitates are used for cutting of materials in bundles.Proper and sufficient clamping of all workpieces in the
bundle significantly influences the service life of the saw blade. The contact pressure plate facilitates vertical clamping of the
workpiece. If a larger bearing surface is required, mount your own fixture of corresponding dimensions onto the contact pressure
plate. Make sure that the guide rods are locked by fixation screws before you start cutting.
Check whether the workpiece is
properly clamped, otherwise you risk its ejection during cutting!
WARNING! When using the vertical vice while cutting the workpieces in HVP bundles, you can cut only at 90°.
The HVP packet for the saw ARG 260 CF-NC includes a new movable clamping jaw and also a small clamping jaw that has to be
connected onto a pre-drilled cast iron fixed clamping jaw in front of the cutting line.
The HVP packet for the saw ARG 300 CF-NC, ARG 300 DCT CF-NC and ARG 330 CF-NC includes a new movable jaw as well as
a fixed jaw.
The HVP packet for the saw ARG 330 DC CF-NC includes extensions for both the movable and the fixed jaw, where the threads are
already predrilled.
Guiding rods are usually supplied in three pieces, in order to allow for cutting of a whole range of sections. It is necessary to replace
the rod before cutting in order to prevent collision with the guide head or the clamping jaw.
Machine type
ARG 260 CF-NC
ARG 300 CF-NC
ARG 300 DCT CF-NC
ARG 330 CF-NC
ARG 330 DC CF-NC
ARG 520 DC CF-NC
width
250
300
360
350
360
700
height
150
175
170
210
190
400
Maximum material HVP
FIXATION SCREWS
FIXTURE
CONTACT PRESSURE PLATE
GUIDE RODS
CONTACT PRESSURE PLATE
ø 69
ø 9
50
