Pilous ARG 300 DCT CF-NC automat, Инструкция по эксплуатации

Страница: 5 / 53

4. 4 .1.Setting the cutting angle
(except the ARG 330 DC CF-NC and the ARG 520 DC CF-NC)
The design of the machine allows for angular cutting without a need to handle the workpiece. To set the desired cutting angle, release
the arm swing locking lever Z and then manually swing the entire saw arm as well as the turntable Y. During swinging, the arm must be
ascended so that the saw blade is located above the level of the loading area of the vice. After you set the desired angle (based on the
angular scale), the turntable with the arm will lock using the locking handle of the table Z. The fixed stop is used for stable setting of
critical angles.
CONTINUOUS ARM
SWING RANGE
TURNTABLE Y
FIXED ARM
SWING STOP 90 °
ANGLE SCALE
TURNTABLE
90°- 45° 90°- 45°
FIXED ARM
SWING STOP 45°
LOCKING LEVER
OF THE TABLE Z
M8 NUT LOCK
VICE PLAY
ADJUSTING SCREW
MAXIMUM
JAW EXTENT
4. 4 . 2 . Adjustment Procedure - Lateral Play of the Vice
You can adjust the lateral play of the vice in all types of saws except for ARG 520 DC CF-NC automat.

‚
ƒ
„
…
† ƒ , „ , …

‚
ƒ
„
…
† ƒ , „ , …
Fixed vice ARG 260 CF-NC
Open the movable vice jaw to maximum extent.
Loosen the M8 LOCKING NUTS and loosen the M8 VICE PLAY SETTING SCREWS.
Carefully tighten the first VICE PLAY SETTING SCREW (right at the movable clamping jaw) up to a point, where you feel that the
screw (through a supporting ball) rested on the bar that pushes to the dovetail.
In this position, tighten the screw with an M8 LOCKING NUT against loosening.
Use the handwheel to move the VICE MOVING BODY, so that the next VICE PLAY SETTING SCREW is in the same position as
the previous screw.
Repeat points until the vice is completely closed and therefore adjusted.
You can watch the video with instructions on www.pilous.cz.
Vices ARG 300 CF-NC, ARG 300 DCT CF-NC, ARG 330 CF-NC, ARG 330 DC CF-NC
Loosen all M8 LOCK NUTS and all M8 VICE PLAY SETTING SCREWS.
Pull the moveable jaw to the half of the maximum opening of the vice against two SCREWS SETTING THE PLAY OF THE VICE.
Carefully tighten these two VICE PLAY SETTING SCREWS (located against the movable clamping jaw) up to a point, where you
feel that the screw (through a supporting ball) rested on the bar that pushes to the dovetail.
In this position, tighten the screw with an M8 LOCK NUT against loosening.
Use the handwheel to move the movable vice jaw, so that the next two VICE PLAY SETTING SCREWS are in the same position as
the previous screws.
Repeat the points until allVICE PLAY SETTING SCREWS are set and secured and the vice adjusted.
ARG 300 CF-NC, ARG 300 DCT CF-NC,
ARG 330 CF-NC, ARG 330 DC CF-NC
ARG 260 CF-NC
FIXED VICE
M8 NUT LOCK
VICE PLAY
ADJUSTING SCREW