5. Commissioning
5.
2
.
Cutting Procedure
Danger of injury!
No cover on the saw blade in the cutting area!
High risk of injury in the operating area of the blade!
5.1. Security Check
Is everything in perfect condition with regard to safety and technical condition?
Are all protective devices mounted properly?
1) Unlock the arm. In ARG 520 DC automat, unscrew the M10x60 bolt (see section 3.5.) on each side of the column and release the
arm.
2) Turn on the POWER SWITCH. The operation system turns on the control panel display.
A yellow screen will appear, showing: “Close the arm cover, unlock the TOTAL STOP and press the yellow-lit SAFETY button”.
3) The MAIN MENU will initialize. Turn on the HYDRAULIC UNIT START
4) Choose MANUAL , SEMI-AUTOMATIC or AUTOMATIC MODE . The performance of the first cut will be described
only for MANUAL and AUTOMATIC MODE.
MANUAL mode
(see Section 4.1.4)
5) You have selected MANUAL MODE .
6) Turn on the HYDRAULIC UNIT START , unless you have already done so in step 3).
7) Open the vices L and R hydraulically . In ARG 260, 300 and 330, open the vice also manually, using a rotary wheel. In ARG 520
DC automat, press it and hold it. In ARG 520 DC automat, the bar simultaneously moves along the movable guide head with the
vice. In ARG 260,300,330 it is necessary to move the bar of the movable guide head manually in front of the movable jaw.
8) Lift the arm up to the upper position (see Section 4.1.4) so that the saw blade is located above the cut material. Stop lifting .
In case the saw blade is now too high above the material, you can adjust this height the following way.
9) Insert the material manually under your saw blade to the desired length of cut.
10) Clamp the vice R .
11) In ARG 260, 300 and 330, move the movable bar in a way that allows moving the guide head towards the cut workpiece to the
distance of 30-50 mm and shut off the control valve.
12) If the arm is too high above the material, lower it down and control the speed of the descent using the control valve. Stop the
descent and shut off the CONTROL VALVE.
13) Press the SAW BLADE START button(see Sec. 4.1.4), to start the saw blade. Set the optimum blade speed.
14) Start the arm descent .
15) Set the optimum speed of the arm descent to the cut by gradual loosening of the CONTROL VALVE and perform the cut.
16) Turn off the SAW BLADE STOP .
17) Lift the arm up to the required upper position and turn off the arm uplift.
18) Open the vice R .
19) Insert a new workpiece, or move the current one.
You can use the servo feed system of the feed vice and move to material after entering the cut length on the screen. The feed vice L
feeds, however, only pieces up to 500 mm, in ARG 520 is it 600 mm.
Click here to confirm the value. After feeding and removing the material, you can manually measure the length of the cut material
and adjust the whole process.
MANUAL MODE
0 9 : 2 0 : 0 3
0 8 / 1 0 / 2 0 1 6
CORRECTI
ON
L
R
AMMETER
65
15
90
BLADE SPEED
m/min
0.0 A
mm
123.5
123.5
1.12
HEIGHT
mm
0
