phyCORE-MPC565 QuickStart Instructions
•
If you wish to verify the Flash download simply click on the
Verify
button to start this procedure.
•
Click on the OK button to exit the
Flash Programmer
tool.
•
Click
No
when you are prompted to save these new settings.
You have now successfully downloaded the pre-existing
Hello_Fl
example program to the MPC565 on-chip Flash.
•
Disconnect the power adapter from Development Board.
•
Disconnect the DB-25 parallel cable.
•
Reconnect the power adapter to the Development Board.
•
Start the program execution by simultaneously pressing the
Reset
(S2) and Boot (S1) buttons on the phyCORE Development Board,
first releasing the Reset and then, two or three seconds later,
release the Boot button.
The red LED D6 on the Development Board will now flash in a
different pattern with three short on/off sequences followed by a
longer pause.
•
Switch back to the HyperTerminal program to view the output of
the demo program, which will print the character string,
"UART_1> Hello world
Running out of internal FLASH (3x LED)“
38
© PHYTEC Meßtechnik GmbH 2009 L-647e_2
