phyCORE-MPC565 QuickStart Instructions
•
The
Status:
line shows the individual steps that are performed
during the Flash download.
•
The following status line will appear at the end of the download
sequence:
•
If you wish to verify the Flash download simply click on the
Verify
button to start this procedure.
•
Click on the OK button to exit the
Flash Programmer
tool.
•
Click
No
when you are prompted to save these new settings.
You have now successfully downloaded the
Hello_Fl
example
program to the external burst Flash on the phyCORE-MPC565.
•
Disconnect the power adapter from Development Board.
•
Disconnect the DB-25 parallel cable.
•
Reconnect the power adapter to the Development Board.
•
Start the program execution by simultaneously pressing the
Reset
(S2) and Boot (S1) buttons on the phyCORE Development Board,
first releasing the Reset and then, two or three seconds later,
release the Boot button.
The red LED D6 on the Development Board will now flash in a
different pattern with three short on/off sequences followed by a
longer pause.
52
© PHYTEC Meßtechnik GmbH 2009 L-647e_2
