PDS-60 Product Guide
9
Connect the PDS-60 to Line Power
Make sure line power is OFF before connecting it to the PDS-60.
The device arrives with line, neutral, and ground wires in the form of flying leads
ready for connection in the power connection chamber. You connect line power to
the leads by using the included push wire connectors.
1. Install a cable strain relief connector in one of the device’s 3/4 in openings in
the power connection chamber. If necessary, use conduit as required by local
electrical codes.
2. Run the mains voltage power cable through the opening. Pull at least 152 mm
(6 in) of wire into the chamber.
3. Strip at least 10 mm (0.38 in) of insulation from the wires. Join the mains line
wire with the flying leads using the three included push wire connectors.
DMX/ETHERNET
IN
DM
X
OU
T
1
2
3
O
S
M
10 mm
(0.38 in)
PDS-60 connected to mains line power
