PDS-60 Product
Guide
6
Mount the PDS-60
Make sure line power is OFF before mounting and connecting. A power screwdriver is
recommended.
1. Position the PDS-60 device in its designated mounting location. Make sure the
mounting location is flat, suitable for the mounting hardware, and clear of debris
and other obstructions.
2. Using four screws suitable for the mounting surface, secure the PDS-60 device
to the surface using the two mounting slots located at both ends of the device.
Install EMI Suppression Cores
The PDS-60 arrives packaged with three EMI suppression cores.
These suppression
cores reduce electromagnetic noise that can interfere with other electrical
equipment. The white suppression cores are for iColor and eW Flex strands or
luminaire leader cables. The black suppression core is for the power cable.
Before attaching the cores, make sure that each set of ferrite metal halves are secure
in their plastic housing.
1. Attach the black suppression core to the power cable:
• Near the end of the cable that connects to the power/data supply, coil the
power cable into a small loop.
• Place the section of the loop where the cord is doubled into the suppression
core. Be sure the cord is securely in the core’s middle.
• Snap the core shut around the doubled cord.
2. Attach a white suppression core to the luminaire strand or leader cable attached
to port 1.
• Near the connection to the power/data supply, coil the strand or cable into
a small loop.
• Place the section of the loop where the cord is doubled into the suppression
core. Be sure the cord is securely in the core’s middle.
• Snap the core shut.
3. Repeat step 2 for the second white suppression core, if necessary.
E
Make sure that there is adequate space
to make all connections to the top and side
of the device.
E
Make sure that the device is securely
attached and free of excessive vibration.
6 in (152 mm)
6 in (152 mm)
6 in (152 mm)
Sized for 13 mm (1/2 in )
trade size conduit
Sized for 19 mm (3/4 in)
trade size conduit
91 mm (3.6 in)
224 mm (8.8 in)
140 mm (5.5 in
)
DMX/ETHERNE
T
IN
DM
X
OU
T
211 mm (8.3 in)
mounting slots
51 mm (2 in)
25 mm (1 in)
20 mm (.8 in
)
DMX/ETHERNE
T
IN
DM
X
OU
T
