Securing the Cover and Sealing PDS-60
After all the power and data connections, addressing, and pre-programmed effects
changes have been made, and you have made sure that all through holes are water-
tight, you may seal the device.
1. Replace the cover, ensuring that the gasket is seated properly and that no wires
are pinched.
2. Attach the cover with the six included screws. Tighten screws to 8 to 10 in-lbs
(1 in-lb = 11.2985 N-cm). If you are installing in a wet or damp location, seal
with RTV silicone.
Installing in Damp or Wet Locations
When installing in damp or wet locations, seal all junction boxes, power supplies, and
other devices with electronics-grade RTV silicone sealant so that water or moisture
cannot enter or accumulate in any wiring compartments, cables, luminaires, or other
electrical parts. You must use suitable outdoor-rated junction boxes when installing
in damp or wet locations. Additionally, you must use gaskets, clamps, and other parts
required for installation to comply with all applicable local and national codes.
Replacing Fuses
PDS-60 has a fuse for each of its ports, protecting
each port from excessive current.
Always replace a blown fuse with a 4 A, 5 x 20 fast blow fuse.
1. Make sure that the device’s power is OFF.
2. Using a Phillips screwdriver, unscrew the six screws holding the cover in place.
3. Remove the blown fuse from its metal clips next to the luminaire and data
connection ports (see image below).
4. Replace the fuse with a new, 4 A, 5 x 20 fast blow fuse.
5. Replace the cover, ensuring that the gasket is seated properly and that no wires
are pinched.
6. Attach the cover with the six included screws. Tighten screws to 8 to 10 in-lbs
(1 in-lb = 11.2985 N-cm). If you are installing in a wet or damp location, seal
with RTV silicone.
E
In wet or damp locations, use electronics-grade
RTV silicone to seal all points of entry in all PDS-60
devices and all connected junction boxes to
prevent water infiltration.
RTV Silicone
RTV Silicone
Fuse
OUT 1
DMX/ETHERNET
IN
OUT 2
DMX
OUT
DAS-000059-00 R01 10 April 2018
Copyright © 2018 Philips Lighting Holding B.V. All rights reserved. Chromacore,
Chromasic, CK, the CK logo, Color Kinetics, the Color Kinetics logo, ColorBlast,
ColorBlaze, ColorBurst, eW Fuse, ColorGraze, ColorPlay, ColorReach, iW Reach, eW
Reach, DIMand, EssentialWhite, eW, EvenBalance, iColor, iColor Cove, IntelliWhite,
iW, iPlayer, Optibin, Powercore and PureGlow are either registered trademarks or
trademarks of Philips Lighting Holding B.V. in the United States and/or other countries.
All other brand or product names are trademarks or registered trademarks of their
respective owners. Due to continuous improvements and innovations, specifications
may change without notice.
Philips Color Kinetics
3 Burlington Woods Drive
Burlington, Massachusetts 01803 USA
Tel 888.385.5742
Tel 617.423.9999
Fax 617.423.9998
www.colorkinetics.com
