Philips eS21, Руководство по установке и эксплуатации

Страница: 20 / 30

Installation & Operation Guide
eS21 LED Raceway
1 8
OPERATION AND PROGRAMMING
LCD Menu Structure (continued)
Continued next page
MOD/PORT CONFIG (Dimmer Module configuration, user-selectable options)
Sub Menu Options Comments
Mod/Port Not Applicable
Displays Module, Port and DMX
Address
Mode
RPC (Reverse Phase Control)
Sets dimmer operation to reverse
phase control
FPC (Forward Phase Control)
Sets dimmer operation to forward
phase control
Non-Dim
Sets dimmer operation to non-dim
operation (On or Off operation only -
no dimming)
LED - RPC (Reverse Phase Control)
Sets dimmer for line voltage LED
fixtures that require locked reverse
phase control dimming.
LED - FPC (Forward Phase Control)
Non Dim % 0 to 100%
When dimmer is set to Non-Dim, this
option sets the dimmer's threshold
level (selection 0 to 100%). Levels
below the set percentage will turn the
dimmer off and levels equal to or
above the set percentage will turn the
dimmer on. *
WARNING: Setting a
dimmer to act as a Non-Dim device
is NOT recommended to control
loads that require a solid-state
relay. Doing so could damage the
device and/or dimmer.
Voltage at Full (VAC) 200 / 220 / 230 / 240 VAC
Sets dimmer operational voltage.
NOTE: Using a lower voltage than
lamp specification can prolong lamp
life.
Transition (uS) 400 / Auto
Options available (in both FPC and
RPC) are either 400 (set) or AUTO
(automatically and continuously
adjusts between 400 or 1000 uS)
Dimmer Curve
Linear / Square Law / Invert / Slow
Bottom / Fast Bottom / Fast Top / Full
at 1 / Out at 100 / Preheat 5% /
Preheat 10% / Hot Patch / Adv Mark
10 (fluorescent ballasts)
Sets dimmer curve (dimming
operation) for each dimmer in the
eS21 LED Strip
High Trim 1 to 100%
Sets the top end of the dimmer
operational limit
Low Trim 0 to 99%
Sets the low end of the dimmer
operational limit
Always On Yes or No
If set to Yes, then the dimmer stays on
to the Low Trim setting.
Preheat Yes / No
Allows dimmer to be set to preheat
mode. Normally preheat mode is used
to "speed up" large wattage lamps so
they behave more like smaller ones
Continued from previous page
MOD/PORT CONFIG (Relay Module configuration, user-selectable options)
Sub Menu Options Comments
Mod/Port Not Applicable
Displays Module, Port and DMX
Address
Non Dim % 0 to 100%
This option sets the relay’s threshold
level (selection 0 to 100%). Levels
below the set percentage will turn the
relay off and levels equal to or above
the set percentage will turn the relay
on.