Philips eS21, Руководство по установке и эксплуатации

Страница: 25 / 30

Replacing a Module
23
eS21 LED Raceway
Installation & Operation Guide
6. Replacing a Module
WARNING! Failure to disconnect power before servicing may result in injury.
To replace a module:
Step 1. Turn off or disconnect all power to eS21 LED Raceway.
Step 2. At module, loosen four screws and partially remove from system ( Figure 9 ).
Figure 9: Removing and Replacing a Dimmer Module
Screw (4 each)
Load / Line / Neutral Connections (see details below)
S21 or eS21
Dimmer Module Communication Connection (Low Voltage)
Neutral A
Line A In
DIP Switches
Dimmer Module
Dimmer Module
Communication Connection
Connections
Neutral B
Connections
Line B In
Load B Out
Load A Out
Dimmer
Module
(rear)
Ground Terminals
ON
1 2 3 4 5 6 7 8
Module 1 - Ports 1 (and 2)*
Module 2 - Ports 3 (and 4)*
ON
1 2 3 4 5 6 7 8
Module 3 - Ports 5 (and 6)*
ON
1 2 3 4 5 6 7 8
LED Raceway
Load Connector Plate
Ground (Earth) Connection
Dimmer Module Rear
DIP Switches
(*See notes below)
*NOTES:
(1) Each module can support either 2 ports of dimming or relays OR 4 ports of LED.
(2) Addressing is set assuming 4 ports. Therefore, eS21 LED Raceways supports 1 - 3 - 5 addresses.