24
A
Switch the receiver on and select programme number 02 on the
receiver or using its remote control.
a
My external receiver does not display the programme
number
During installation,the external receiver will be switched to a
different programme number.
- Please check the TV show in the 'Video window' in the left top corner
of the screen.
- Check whether the picture changes during the next step
(
OK
L
button).
B
Read the information on the screen carefully.
Confirm with
OK
L
.
P
The DVD recorder will now attempt to use the G-Link
connection on the external receiver to select a different
programme number (e.g.12). This programme number
depends on your external receiver.
C
Has the external receiver been switched to the programme
number displayed on the screen?
If this is the case, select '
YES
'.
If no switching has taken place, select '
NO
'.
a
My external receiver has not switched to the other
programme number.
- Check that the external receiver is connected and switched on.
- Check the connection and position of the G-LINK transmitter.
- For another attempt with a new code of the chosen brand,select '
NO
'.
- Confirm with
OK
L
on the remote control.
- If the receiver has not switched yet,select '
NO
' again and confirm with
OK
L
. It may take several attempts for a receiver brand.
If you return to the setup screen after confirming '
NO
',your receiver
may not have been installed.
- In this case,tune your external receiver to the TV channel which
transmits the GUIDE Plus+
®
information (see table in the section
'General information'). If this TV channel is available at the internal
tuner of the DVD-recorder,select this channel.
- Wait till the GUIDE Plus+
®
information is loaded (24 hours) and try
the switch again.
The control data of external receivers are automatically updated
(completed) via the GUIDE Plus+
®
system. This is done through the
aerial,the cable,or the external receiver. You do not need to bring the
device to a service centre.
- If your receiver still does not switch,note the type and manufacturer of
your external receiver and call the customer support service in your
country. You will find the telephone number on the back of this
instruction manual.
À
Your external receiver has now been installed.
Á
Press
OK
L
to return to the setup overview. Check the settings
shown on the screen.
O
If the settings are not correct, choose the line in which you
want to change the settings and confirm with
OK
L
.
Â
Press the green function button
E
to leave the screen.
O
If you want to view a demonstration of the GUIDE Plus+
®
system select '
View Demo
' with
B
O
and confirm with
OK
L
.
If you start the demo, programmed recordings may be deleted.
O
If you do not want to see the demonstration of the GUIDE
Plus+
®
system, end using
GUIDE/TV
J
.
The setup process for the GUIDE Plus+
®
system is complete.
Continue with 'Finalise set up of the external receiver'.
a
I want to install additional external receivers
When installing additional external receivers,please observe the following:
The external receiver which is controlled by the G-LINK transmitter must
be
below
the other additional receivers. The IR(infrared) remote control
signal is reflected diagonally upwards and can therefore be used to control
additional external receivers which are above it.
ENGLISH
Initial Installation of the GUIDE Plus+ system
