Service Modes, Error Codes, and Fault Finding
5.
Figure 5-9 “Semi Stand-by” to “Stand-by” flowchart
transfer Wake up reasons to the Stand by µP.
Stand by
Semi Stand by
Disable all supply related protections and switch off
the DC/DC converter (via the Enable-3V3 I/O line)
Switch OFF all supplies by switching HIGH the
standby I/O line..
Switch AVC system in reset state
Important remark:
release reset audio 10 sec after
entering standby to save power
switch off the +1V2 DC/DC converters
Wait 5ms
Wait 10ms
Switch the NVM reset line HIGH.
Delay transition until ramping down of ambient light is
finished. *)
If ambientlight functionality was used in semi-standby
(lampadaire mode), switch off ambient light (see CHS
ambilight)
*) If this is not performed and the set is
switched to standby when the switch off of
the ambilights is still ongoing, the lights will
switch off abruptly when the supply is cut.
Switch Memories to self-refresh (this creates a more
stable condition when switching off the power).
I_17960_065.ep
s
22050
8
Содержание 32PFL7403D/10
Страница 59: ...Circuit Diagrams and PWB Layouts 59 Q528 2E LB 7 Layout LCD Supply 37 B 42 Top Side H_16750_070 eps 110108 ...
Страница 60: ...60 Q528 2E LB 7 Circuit Diagrams and PWB Layouts Layout LCD Supply 42 Bottom Side H_16750_071 eps 110108 ...
Страница 126: ...126 Q528 2E LB 7 Circuit Diagrams and PWB Layouts Personal Notes E_06532_013 eps 131004 ...