Mechanical Instructions
4.
4.3
Assy/Panel Removal ME8(+) Styling
4.3.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
Note:
it is
not
necessary to remove the stand while removing
the rear cover.
Warning:
Most sets have an additional hatch located in the
rear cover. These are meant for disconnecting the flat cables to
the AmbiLight units in the rear cover,
before
the rear cover is
lifted from the set. The hatches are not always located at the
same place for all sets, therefore the figures below are only
meant as indication.
It is mandatory to locate these hatches first, open them, and
unplug connectors behind. Lifting the back cover without
having done so, could result in damaging the connectors
inside!
Refer to next figures for details.
1.
First remove the screws [1] from the back cover hatch and
remove the hatch.
2.
The unplug connector [3].
3.
Remove the screws [2], gently lift the back cover from the
set and unplug the Ambilight power connector [4].
4.
Lift the back cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
Figure 4-14 Back Cover Removal [1/3]
Figure 4-15 Back Cover Removal [2/3]
Figure 4-16 Back Cover Removal [3/3]
H_17650_100.ep
s
1
8
010
8
2
2
2
2 2
2
2
2
2
2
2
2
2
2 2
2
2
2
2
2
1
1
2
2
H_17650_099.ep
s
1
8
010
8
3
H_17650_101.ep
s
1
8
010
8
4
Содержание 32PFL7403D/10
Страница 59: ...Circuit Diagrams and PWB Layouts 59 Q528 2E LB 7 Layout LCD Supply 37 B 42 Top Side H_16750_070 eps 110108 ...
Страница 60: ...60 Q528 2E LB 7 Circuit Diagrams and PWB Layouts Layout LCD Supply 42 Bottom Side H_16750_071 eps 110108 ...
Страница 126: ...126 Q528 2E LB 7 Circuit Diagrams and PWB Layouts Personal Notes E_06532_013 eps 131004 ...