2
.
PAN08 can not control the speed of motor.
3. It may have some distance error caused by motor start up time.
4. If user found the error become significant, you may using S1 or S2 move
shutter to the end or remote move shutter to 0% and 100%, and that will
automatically calibrate this error.
3-3.4
MULTILEVEL SWITCH STOP LEVEL CHANGE:
When receive Multilevel Switch Stop Level change Command PAN08 will stop the
motor.
4 SCENE ACTIVATION COMMAND CLASS
4-1 Scene Activation Set Command
：
When PAN08 receive Scene Activation Set command, it will read the level of the pre-
configured Scene ID from EEPROM. And it will be controlled as a Multilevel Switch
Set command that described in 3-1. The Dimming Duration of the command will be
ignored because PAN08 can not control the speed of motor.
5 SCENE ACTUATOR CONFIGURATION COMMAND CLASS
5-1 Scene Actuator Configuration Set Command
：
[Command Class Scene Actuator Configuration, Scene Actuator Configuration
Set, Scene ID=1~255, Override bit=0, Level=0~99 or 255] The current
setting of PAN08 will not be override.
[Command Class Scene Actuator Configuration, Scene Actuator Configuration
Set, Scene ID=1~255, Override bit=1, Level=0~99 or 255] The Level
value in this Command is associated to the Scene ID.
5-2 Scene Actuator Configuration G
et Command
：
[Command Class Scene Actuator Configuration, Scene Actuator Configuration
Get, Scene ID=1~255 ]
[Command Class Scene Actuator Configuration, Scene Actuator Configuration
Report, Scene ID=1~255, Level=0~99 or 255, Dimming Duration=0~0xFE] Report
the Pre-configured Scene ID of PAN08.
6
Z-wave’s Groups introduction (Association Command Class Version 2 )
There is only one group called Group1
，
there is only one node for Group1 which
support MULTILEVEL_SWITCH_REPORT
、
METER_REPORT_COMMAND_V3
、
ALARM_REPORT.
6-1 Report the shutter position
：
Every time when user press S1 or S2 and let shutter to move, PAN08 will report the
position status to controller, and at the moving process when change over 10%
PAN08 will send Multilevel Switch Report to Group 1 as well.
Multilevel Switch Report
：
Ex. Report position at 30%
[Command Class Multilevel Switch
，
Multilevel Switch Report
，
Value = 30(%)]
7
