Phcbi MCO-5M Series, Руководство по эксплуатации

Страница: 29 / 56

27
ROUTINE MAINTENANCE
To use this unit in a clean condition, clean the chamber and the inner attachments at least once a month.
1.
Remove the inner attachments by the procedures shown on page 22.
2. Clean the chamber and the inner attachments by the procedures shown on page 21.
3. Install the inner attachments by the procedures shown on page 24.
● When there is excessive dirt, contact our sales representative or agent.
CORRECT OPERATION
Use the following procedure to start trial operation or actual operation of the incubator.
1. Install the incubator correctly, referring to “INSTALLATION
”
on page 15.
2. Remove the packing materials from the chamber and inner attachments. Clean and disinfect the
chamber and inner attachments, referring to above “ROUTINE MAINTENANCE”.
3. Add approximately 1.5 L of sterile distilled water to the humidifying pan. (Refer to page 25.)
4. Connect the power supply removable cord* to the outlet. Turn ON the power switch at the lower part of
the incubator.
*For EU user: 2 power supply removable cords are provided.
For UK For EU countries other than UK
WARNING
Always use the power supply removable cord that is provided. Other power supply cord may cause
electric shock or fire.
 The provided power supply removable cord is only for this product.
Never use it for any other products.
Note:
The humidity in the incubator chamber is adjusted to the optimum setting. To prevent condensation on the
surface inside chamber and the inner door, there is a low-temperature area under the humidifying pan in
the bottom of chamber to recondense evaporated moisture. Condensation may occur around the
humidifying pan at the bottom of the chamber (on the inside of the humidifying pan cover), but this does
not indicate a problem.