24
INSTALLING INNER ATTACHMENTS
Use the following steps to install the inner attachments properly.
1.
To reinstall all the attachments, perform the procedure in reverse order from step 10 on page 23.
2.
When installing the fan, insert it to the motor shaft securely. Lightly turn the fan manually to make sure
that it does not strike the rear panel. Then put on the central spring. (Fig. 1)
CAUTION
If the fan is not inserted deep enough, the intended velocity performance cannot be achieved, which may
cause culture failure or insufficient decontamination.
3.
To install the rear duct, confirm 4 pins are securely installed in the 4 holes of rear duct. (Fig. 2)
CAUTION
If the rear duct is fixed insecurely, the intended velocity performance cannot be achieved, which may
cause culture failure or insufficient decontamination.
Fig. 1
Fig. 2
4.
To install the side support, confirm the direction of fixing holes as shown in Fig. 3.
5.
As shown in Fig. 4, set the tray with only the front edge bent up. If the tray is set in the wrong direction,
it may not be level and may become unstable.
2.
Install the spring afterwards.
3. Lightly turn the fan manually to
make sure that it does not
strike the rear panel.
1.
Push the fan deeply.
Fig. 3
Bent up
Fig. 4
Содержание MCO-5M Series
Страница 2: ......
