PGO BR-500, Руководство по обслуживанию

Страница: 298 / 330

Caution : Do not disperse oil in the environment. Oil,gasket and filter should be disposed of
according to the regulations in force.
Warning : Avoid touching parts of the engine when hot,as this may cause burns.
Tightening torque:
Engine oil drainage cap: 24 ~ 30 N
-M
Oil filter: 12 ~ 16 N
-M
Oil used: Selenia HI Scooter 4 Tech
- Remove the silencer.
- Remove the loading cap (
A
)
- Remove and clean the net filter of the
drainage cap "
B
" using compressed air.
- Use a filter tape wrench to remove the
cartridge filter "
C
" .
- Make sure that the O-rings of pre-filter and
drainage cap are not worn.
- Lubricate the O-rings and replace net filter
and oil drainage cap; tighten at the prescribed
torque.
- Replace a new cartridge filter after
lubricating the O-ring, then screw it up to
touching the gasket and tighten further to the
prescribed torque.
- Replace the silencer.
- - Fill in approx. 1700 cc of engine oil.
- -- /span>Start the engine, let it run for a few minutes and stop it.
- -- After about 5 minutes, check the level and top up if necessary
without never
exceeding the OIL level
N.B.
: If oil is replaced without replacing the cartridge filter (1?coupon), fill with approx. 1500
cc instead of 1700 cc since a part of the lubrication circuit is still full.
PGO BR-500 ENGINE
B
P.3-18
PGO BR-500 ENGINE
Maintenance