EN – 53
EN
Maintenance
A
Air inlet tube (7) reassembly
Install the spring (
6
) and screw the air inlet tube (
7
) and unscrew it of the number of
turns given, when disassembling (usually 3 or 4 turns) (
see page
48
).
Motor coupling
(
see page N-12)
To make sure motor coupling does not
touch fan, adjust distance from motor
plate (
dimension A
on the drawing):
To perform this adjustment, use adjusting
tool in tool kit (
see page 45
).
Pump models
Dimension «A»
2033 SD - C1 - C2
16.6 ± 0.5 mm
2063 SD - C1 - C2
23.3 ± 0.5 mm
Oil inlet tube (1) reassembly
(C2 Model)
When positioning the oil inlet tube (
1
), make sure that screw is properly centered in the
centering hole, the collector located at the upper part of the tube must line up under
the oil fill port in the oil casing.
Installing the filter cartridge (33)
(C1 model)
Install the case bushing (
31
) on the oil pump (
11
) (the direction is defined by the
centering pins which allow to have a right oil circulation in the cartridge). Than, screw
the filter cartridge (
33
).
Installing oil pressure
indicator
(C2 Model) (
see page N-10)
Place a strip of Teflon tape on thread of connectors (
54
) and (
10
) (
N-6
).
Position one end of tube (
56
) in connector (
10
) (
N-6
) and the other end in the hole in
the frame provided for this purpose.
Install a new o-ring (
52
), the washer (
53
) on the top end of the tube and screw (
54
) on
the frame (
1
).
Screw connector (
10
) (
N-6
) into oil pump (
11
) (
N-6
).
Change the O-ring (
51
) and screw the screw (
50
).
Installing the oil sight glass
(see page N-8)
Install a new flat seal (
20
) then the sight glass (
21
), the protection (
22
) (
SD model
) and
the flange (
23
).
Secure with 2 screws (
25
) equipped with washers (
24
) to a maximal torque of 12Nm ±
2 Nm.
After reassembling, fill the oil casing with oil (
see page 17
) before start-up the pump
(
see page 29
).
Fill with oil
SD, C2 Series
C1 series pump
Place the O-ring (
52
), the glass (
53
) and the circlip (
54
) on the Oil sight glass body (
51
).
Place the O-ring (
50
) and screw the oil sight glass body equipped (
51
) using a 50 mm
spanner.
Содержание Pascal 2033 C1
Страница 21: ...EN 20...
Страница 29: ...EN 28...
Страница 56: ...EN 55 EN Maintenance...
Страница 57: ...EN 56...
