Pfeiffer Vacuum Pascal 2033 C1, Руководство по эксплуатации

Страница: 38 / 71

EN – 37
EN
Maintenance
General precautions
Safety instructions for maintenance
For normal operation, the maintenance of 2033-2063 m
3
/h series pumps only require
regular oil changes ( see page 41 ).
Insufficient tightness after servicing could result in chemical hazards. Always
perform a leak test after maintenance.
Certain gases can become corrosive and toxic when trapped in oil. Always
wear protective gloves when handling used and dirty pump oil, drain it
into a closable container, and do not breathe the oil fumes. Always use
fully self-contained breathing apparatus.
During pump removal, draining or maintenance operator could be in
contact with process residues which could cause severe injury or death.
Ask your safety department for instructions according to the local
regulations.
We recommend to:
- To purge the pumping installation with dry nitrogen.
- Wear gloves, protective glasses and, if required for the used gases, a
breathing mask.
- Ventilate the premises well.
- Do not eliminate maintenance waste via standard disposal channels. Have
it destroyed by a qualified company if necessary.
- Install the inlet and exhaust blanking plates, thus accessories are
delivered with the pump.
Decontamination – product dismantling
According to the regulations 2002/96/CE about Waste of electrical and
electronical equipments, and 2002/95/CE about Restriction of Hazardous
substances, the manufacturer provides a recycling paid service for the
end of-life of waste electrical and electronic equipment.
Any obligation of the manufacturer to take back such equipment shall
apply only to complete not amended or modified equipment, using
adixen Vacuum Products original spare parts, delivered by adixen,
containing i.e. all its components and sub-assemblies.
This obligation will not cover the shipping cost to an adixen take back
facility.
If you return the product to an adixen repair service center, please make
sure you follow the «procedure for returning products» and fill in the
declaration of contamination found in the end of the manual or on the
website.
Maintenance must be performed by a skilled maintenance operator trained
in the relevant health and safety aspects (EMC, electrical hazards, chemical
pollution, etc.).
Isolate the product from all energy sources (mains electricity, compressed air,
etc.) before starting work.