Pfeiffer Vacuum Pascal 2033 C1, Руководство по эксплуатации

Страница: 40 / 71

EN – 39
EN
Maintenance
Incidents Causes Corrective actions
The vacuum pump does not produce
a vacuum (
continued
)
Ultimate pressure obtained: a few 7.5 x10
-3
Torr (10
-2
mbar)
Gas ballast knob open (or supplied
with dry nitrogen C1,C2 Series). • Close the gas ballast or stop the dry air
supply.
O-ring pinched. • Replace by a new one.
One of the seals is damaged. • Replace by new ones.
One of the HP safety valves is
damaged. • Replace the HP safety valve.
Lubrication holes blocked. • Disassemble and clean.
Incorrect anti-noise device setting. • Repeat the assembly and setting.
Part forgotten in reassembly. • Repeat the reassembly.
Filter cartridge clogged. Replace by a new cartridge.
Accessories
At the pump exhaust, the installation
produces an exhaust pressure of
1,125 Torr (1.5 bar). • Check the installation.
Oil mist eliminator cartridge clogged. • Replace.
Noisy pump Oil level too high. • Drain and fill with a new oil.
Oil contaminated (presence of
particles). • Drain, flush and refill with clean oil.
Pump not prepared for the oil used. • Check the pump configuration or the
type of oil.
Incorrect motor power supply. • Check the power supply.
Motor bearings damaged. • Replace the motor after inspection.
Motor coupling incorrectly set or
damaged. • Check the setting, replace the motor
coupling.
Incorrect fan assembly. • Check the assembly.
Incorrect anti-suckback device
assembly. • Repeat the assembly.
Vanes damaged or stuck. • Replace the vanes.
Pump too hot Ambient temperature too high. • Check that the temperature is between
12 and 45 °C.
Pump placed in a poorly ventilated
place or vents blocked. • Check the installation.
Operation at high pressure
P > 22 Torr (30 mbar). • Study an outside cooling drvice.
Excess pressure at exhaust. • Check the exhaust line.
Motor in over-voltage or motor in
short-circuit. • Check the voltage, replace the motor.
All series C1 C2 C1 and C2