Pfaff PLUSLINE 2483-3/03-980 Series, Руководство по настройке, Страница: 33 / 58

Adjustment
33
15
.09
Adjusting transmitted light sensors
Rule
The difference between one and more material layers should be reliably detected.
O
Switch the machine on.
O
Press the F3 key to call up the menu to adjust the transmitted light sensors.
F3
Rx Tx L - L =
-96- Lo --- ===
O
Place a single material layer under the sensors.
O
Press “+” using the corresponding +/- key to start the adjustment for the single materi-
al layer.
O
Briefly move the material layer back and forth under the sensors.
O
Press “-” using the corresponding +/- key to end the adjustment for the single material
layer.
O
Place a double material layer under the sensors.
O
Press “+” using the corresponding +/- key to start the adjustment for the double materi-
al layer.
O
Briefly move the material layers back and forth under the sensors.
O
Press “-” using the corresponding +/- key to end the adjustment for the double material
layer.
O
Increase or decrease the transmission power if necessary using the corresponding
+/- key .
O
Displays the transmission power of the upper sensor.
O
Press the F3 key and carry out a test seam.
O
Switch the machine off.
L -
L -
L =
L =
Tx
Rx
F3