PETIT auto wash Accutrac 360-t, Руководство по установке

Страница: 3 / 32

Petit Auto Wash Inc.
360-t Installation Manual www.PetitAutoWash.com P a g e | 3
Accutrac 360-t Tunnel
1. Wash Bay Equipment
Assembly Note: Most fasteners supplied use nylon locking nuts, threads must be treated with anti-
seize before assembly. Medium strength thread locker (Loctite 242, Blue) must be used on all other
fasteners.
1.1. Pre-Install:
Mark the floor where all 4 frame legs will sit. Use a transit level, to measure the floor elevation at those
4 points. Identify the highest point and use it as a reference. Determine how much lower each of the 5
points and note the difference. Use leg shims (optional) to level each leg to match the reference height
± 3/16”.
1.2. Unloading:
To unload the truck and install the equipment you will need:
•
Minimum 6,000 lb. Lifting capacity forklift with side-shift capability.
•
Minimum 5ft to 6ft long fork extensions.
•
Caster Wheel Kits are available that attach to shipping crates and bridge cradles.
Be extraordinarily careful when picking the crate up from the lifting end. The weight and length make
it possible to tip the forklift over when transporting. Drive slowly, keeping the crate as low to the
ground as practical.
1.3. Unpacking:
The Bridge comes bolted on top of a steel cradle; this is used to transport & lift the Bridge onto the Main
Rails. The Top Washer is folded up on top of the Bridge.
When unpacking, cut any ties to the steel Cradle but be careful to leave the T-Bars & Spray Arms tied up
to the Bridge. Remove the Top Washer Cover from on top of the Bridge. Leave the steel transport
Cradle firmly attached to the Bridge
Remove the E-Chain, legs, beams and other items from under the Cradle. Casters are available that bolt
into the bridge cradle. This makes it easy to maneuver the machine into the wash bay.