PETIT auto wash Accutrac 360-t, Руководство по установке

Страница: 5 / 32

Petit Auto Wash Inc.
360-t Installation Manual www.PetitAutoWash.com P a g e | 5
Accutrac 360-t Tunnel
Attach the D.S. & P.S. Main Rails snug, but do not fully tighten the fasteners. Be sure to identify the rails
correctly, placing them in the correct position with the 4-bolt flange holes towards the bottom.
Attach the E-Chain Trough with E-Chain in it, to the Passenger Side Legs.
At this point use a level and verify the legs are plumb from front-to-back and left-to-right. Push them
into position if needed, tighten all rail kit fasteners, recheck the legs and finally fully tighten the floor
anchors on all 6 legs. This step is important as it will insure that the upper framework stays plumb and
square.
Do not over tighten the fasteners in the drive rails. This can crush the tubing and cause
alignment issues for the drive wheels.
The Entrance and Exit Proximity Target Flags are already mounted on the P.S. Main Drive Rail. Verify that
the flags are 4” from the end of the bridge rail. The Home Proximity Target Flag is already attached to
the D.S. Main rail. Verify that the flag is 26- 1/4” from the entrance end of the D. S. Main Rail.
Bridge Rail End Stops are directional and are already fastened to the inboard side of the Main Rails, at
both the entrance and exit end. If the End Stops must be removed for any reason, verify that they are
installed before beginning the startup procedure.
Install the E-Chain Bulkhead on the P.S. Entrance Leg. (See drawing under section: 1.7 E-chain)