PETIT auto wash Accutrac 360-t, Руководство по установке

Страница: 12 / 32

Petit Auto Wash Inc.
360-t Installation Manual www.PetitAutoWash.com P a g e | 12
Accutrac 360-t Tunnel
1.5. Raising the Bridge:
Note: Combined weight of Bridge & Cradle is 1,000 lbs. The steel Cradle is used to transport, lift and
position the Bridge into place. To assist in transport, casters are available for the cradle. Make sure
the Cradle is securely attached to the bridge and all the fasteners are tight.
Position the fork lift on the Exit side of the Bridge. If it is necessary to pick the Bridge up from the front
(entrance side), you must first unplug the power wires & remove both halves of the Front Cover.
Verify that the Bridge Proximity switches are adjusted back, nearly flush with the bridge plates, so they
will easily clear the rails & limit flags.
Remove the D.S. Main rail completely, or you can remove all but 1 bolt and swing the drive rail out of
the way without completely removing it. and lift the Bridge while clearing the E-Chain and P.S. Rail.
Then re-attach the D.S. Rail, side-shift and lower the Bridge into place.
If loading the bridge from the Exit end, leave 1 bolt in the Entrance end of the DS Main Rail, If loading
from the Entrance, leave one bolt in the opposite end.
Now remove the bolts that hold the Cradle to the Bridge and lower the Cradle to the ground.
Flip the Bridge Keeper Brackets 180- degrees and keep on the outboard side of the Bridge End Plates,
under the Rails. Verify that the Bridge End Stops are bolted on the inboard side of the Main Rails.
Unfold the Spray Arms. The spray arm breakaway force will be adjusted later.
Install the T-Bars and fold the excess length of photo-eye cables back up into the wire duct. Tuck the
sensor array junction box vent into the top of the T-bar. (Note that the PS T-bar Mount also holds a
photo-eye bracket. Use a level to make sure bracket is straight up/down.
Note: The T-Bars are fastened
to their mounting blocks with a shear bolt. Do not over-tighten the shear bolt. Do not replace with a
regular bolt. Two replacement shear bolts are provided in the spare included parts kit.
Re-install and adjust the Entrance and Exit Prox Switches on the Bridge. The face of the prox switch
should be 3/16 to ¼” from its target flag. (The face of the prox switch will protrude approximately 3/4
to 13/16” beyond the plate it is mounted in).
Unfold the Top Washer, attach the 3/4” feed hose and install the cove r.