Permobil Trax, Руководство по обслуживанию

Страница: 50 / 64

Fitting accessories
50
Fitting bows
Fitting
1. Remove the centre screw which holds the
electronics. Fit the rear mounting with 3
M6x40 and plain washers. See the figure to
the right.
2. Fix the side bows on the pins in the rear
mounting. See the centre figure to the right.
NB. These run in oblong grooves. Screw
them in place with 2 M8x16 and plain
washers.
NB. The M10 bolts for the pins are
tightened later.
3. Adjust the position of the side bows against
the front corners of the battery box so that
they can be screwed in place with 6 M5x12
and plain washers. Then tighten the pins two
M10x16 bolts and plain washers.
4. Fit the upper bow in the welded tubes of the
side bows. Fix the upper bow with the two
star handles. See the bottom figure to the
right. Ensure that the upper bow can easily
be removed from the side bows.
5. Then tighten all the bow's screws.
Removal
1. Loosen the star handles and lift off the upper
bow.
2. Unscrew the side bows rear 2 M8x16 screws
and plain washers.
3. Loosen the front screws of the side bow.
Each mounting is held in place with three
M5x12 screws and plain washers. See the
top figure to the right.
4 . Lift the side bows off the chair.
5. Unscrew the 3 M6x40 screws and plain
washers of the rear mounting.
Also see Assembly Instruction PAB 3262.
Fitting accessories
Mounting of the bow at the front
Mounting of the bows at the rear
Loosen the star handle when only
the main bow is to be lifted off
M8x16
M5x12
M6x40
Bow
Mounting of the side bow at the rear
M8x16
M10x16