Permobil Trax, Руководство по обслуживанию, Страница: 33 / 64

Changing the steering wire, front wheel adjustment
33
Changing the steering wire
1. Remove the cover. See page 7.
2. Remove the foot plate. See page 32.
3. Remove the protective plate under the front
wheel assembly. See page 32.
4. Loosen the steering wire's ball joint, which is
located at the very front in the steering plate of
the front wheel assembly.
It is loosened using the nut which is located on
the lower side of the front wheel assembly.
5. Loosen the steering wire's mounting at the rear
edge of the foot plate.
6. Unhook the spring in the rear wheel assembly
which fixes the steering wire in the right position.
See the figure to the right.
7. Cut off the cable ties which fix the potentiometer
and front light cables to the steering wire.
Loosen the cable holder in the rear wheel
assembly. See the figure below.
8. Detach the steering wire from the joystick mounting
and the holder on the chassis.
9. Change the damaged wire.
Place the new wire in the same position as the
wire replaced.
10. Screw the steering wire's ball joint in place in the
front wheel assembly's steering plate. Fix the
steering wire in the mounting at the very rear of
the foot plate.
11. Fix the cable between the batteries as shown in
the figure to the right.
NB. Do not tie the
steering wire together with the brake wires and
the pinch protection cables.
12. Fix the cable in the cable holder in the rear
wheel assembly. Only the steering wire is to be
fixed in the holder.
NB . No cable tie must be mounted so that it
prevents the steering cable from sliding in the
cable holder (20 cm).
13. Screw the steering wire in place in the joystick
mounting. Choose a hole so that the joystick
ends up in a suitable position.
Fix the steering wire in the chassis steering wire
mounting.
14. Hook the spring in the mounting in place on the
cable and on the chassis.
Tie the potentiometer and front light cables
together with the steering wire.
NB. No cable tie
must be mounted so that it prevents the steering
cable from sliding in the cable holder (20 cm).
15. Refit the protective plate, foot plate and cover.
Changing the steering wire, front
wheel adjustment
Front wheel assembly
Mounting on chassis, joystick
Spring in rear wheel assembly
Cable holder
Cable tie between batteries
Steering wire mounting