Permobil C300, Руководство по обслуживанию

Страница: 60 / 68

60
Troubleshooting
Troubleshooting VR2
VR2 electronics diagnostics
Battery voltage indicator
Each time the wheelchair is started, parts of the wheelchair’s electronics are checked. If any fault has
occurred in these parts, this is displayed on the control panel’s battery voltage indicator and the indicator
for speed/driving profile in the form of one or more flashing lamps.
Troubleshooting and repairs must always be performed by competent personnel with good knowledge
of the wheelchair’s electronics. More information on troubleshooting and remedies can be found in the
service manual for this wheelchair model.
Permanently on
Everything is in order. The number of lamps that light up depends on the voltage remaining in the
batteries. If the batteries are fully charged, all the lamps light up.
Slowly flashing red lamps, 1 - 2
The batteries need to be charged immediately.
Flashing fast, 1 - 10 lamps
A fault has been detected in the wheelchair’s electronics and the wheelchair cannot be driven.
• Switch off the wheelchair.
• Check that all visible cables and the cable to the control panel are connected correctly.
Switch the wheelchair on again. If the fault persists, count the number of flashing lamps and check for
a possible cause and remedy in the table on the adjoining page.
Do not use the wheelchair until the problem has been remedied or you have received other instructions
from your service contact.
Any error signals on the indicators are not displayed while the wheelchair is being driven. They appear when it is next started.
Diagnostics should only be performed by persons with sound knowledge of the wheelchair’s electronic control system. Incorrect
or poorly performed repair works may make it dangerous to use the wheelchair. Permobil cannot be held responsible for any
personal injury or damage to the wheelchair and its surroundings that occurs on account of incorrect or poorly performed repair
work.
m
WaRnIng
m
nB