Pereko KSP Spark 14, Руководство по эксплуатации и обслуживанию

Страница: 20 / 24

20
Page Operation and maintenance manual for the KSP Spark series boilers equipped with feeders. The producer reserves the right to introduce technical modifications.
4.6.3. Combustion chamber cleaning
Clean the combustion chamber, remove ash accumulating in the
chamber every week.
4.6.4. Cleaning window panel in the
doors
The glass panel in the doors should be cleaned when it is cold
and using ammonia-based degreasing and non-aggressive
agents such as a solvent. Do not allow contact of aggressive
agents with a paint covering the boiler because they could dam-
age it. The doors should be left open if the glass panel is hot prior
to cleaning to cool it down. Do not use materials, which may
damage or scratch the glass.
4.6.5. Battery replacement in remote
control
Replace used up the battery with a new one CR2025 3V paying
attention to the correct setting of the poles (pole are marked
on the remote control) and then close the remote control and
dispose of old battery in accordance with the applicable regula-
tions. Use only above-mentioned batteries.
4.6.6. Flue gas fan cleaning
NOTE: all operations connected with cleaning and/or
maintenance should be carried out when ELECTRICAL SUP-
PLY IS CUT OFF!
The boiler is equipped with flue gas fan located in its rear part.
Possible deposits of dust or ash, accumulating on fan blades,
lead to non-uniform and loud operation. It is necessary to clean
the fan at least once a year. The cleaning should be carried out
only by the service or qualified specialist because this operation
requires disassembling some parts of the boiler.
4.6.7. Service inspection and boiler
maintenance
These works are planned for execution min. once per year by
the service. They are indispensable to ensure efficient operation
of the equipment and they are a warranty of its safe operation.
• Precise cleaning of combustion chamber and heat exchanger;
• Cleaning of the flue gas motor, disassembly and cleaning
of the flue gas exhaust ducts, application of new silicone in
locations where it is foreseen;
• Inspection and checking of tightness of seals, their replace-
ment and applying the silicone in locations where it is
foreseen;
• Emptying and cleaning the tank;
• Inspection of electrical part and electronic components;
• Cleaning and inspection of pipe and pressure switch;
• Inspection and possible replacement of wear and tear com-
ponents: furnace, heater, ash drawer etc.
• It is recommended to carry out an inspection of the heat ex-
changer and remove mineral and lime deposits once a year
for models with the generation of tap water.