Pereko KSP Spark 14, Руководство по эксплуатации и обслуживанию

Страница: 14 / 24

14
Page Operation and maintenance manual for the KSP Spark series boilers equipped with feeders. The producer reserves the right to introduce technical modifications.
4.3. Firing up in boiler
1. Make sure that pellet is in the fuel container.
2. Check whether the furnace doors are tightly closed.
3. Make sure that furnace is clean, ash and combustion residues
as well as unburnt pellet are removed.
4. Fill feeder pipe during first charging by selecting “manual
loading” from the menu 6. Feeder starts operation and will
be filled with pellet after pressing the arrow (1). Shutdown
the feeder with the switch on/off button when the sound of
falling pellet to the box is heard.
5. Press start button (4) for approx. two (2) seconds to start
the boiler. Combustion process consisting of three stages
starts after this operation: Loading, firing, stabilization of
operation.
NOTE! The temperature on the boiler should not be set be-
low 60°C! The too low temperature in boiler leads to the
formation of condensate in the boiler and its accelerated
wear!
4.4. Description of controller panel
The screen on the panel displays information on boiler operating
conditions. It is possible to move to various pages and execution
of available settings, depending on access level, after entering the menu. The displayed pages can have other meaning as-
signed to an item on the screen depending on the selected oper-
ation mode. Functions of the lamps located on the control panel.
Starts settings of water
temperature
Increases value
Decerases value
Flue gas vent.
DHW pump
Circulation pump Boiler status
Power decrease
Next submenu
Power increase
Previous submenu ON/OFF
RESET
Clock Water temp. Igniter
Local thermostat Chronotermostat
Screw-conveyor feeder
Access to menu
Alarm