PERCo TTR-04CW-24, Руководство по сборке и эксплуатации

Страница: 21 / 26

Assembly and Operation Manual
20
10 TRANSPORTATION AND STORAGE
The turnstile in the original package should be transported in closed freight containers or
other closed type cargo transport units.
During storage and transportation the boxes can be stacked no more than 4 layers high.
Storage of the turnstile housing is allowed in dry indoor facilities at the ambient air
temperature from -40°
С to +45° С and relative air humidity of up to 75% at +15° С . The
environment should be free of acid and alkali vapours and gases that cause corrosion.
Storage of the control unit is allowed at ambient air temperature from -10° С to +40° С and
at relative air humidity of up to 80% at +25° С . The environment should be free of acid and
alkali vapours and gases that cause corrosion.
Note:
If the control unit is to be stored for a long time, it is recommended keeping its
accumulator battery separately, observing requirements to storage of hermetic
unused batteries.
After transportation or storage at temperatures below zero or at high air humidity, prior to
the installation the turnstile must be kept in the original package for no less than 24 hours
indoors at room temperature.
11 MAINTENANCE
The turnstile housing maintenance is required once a year or in case of failures. The
maintenance should be carried out by a qualified mechanic who has studies carefully this
Manual.
Prior to the turnstile maintenance works disconnect the CU power supply from the AC
mains: set up the
“Power” toggle switch to the OFF position, the “Battery” toggle switch
— to the External position; take out the plug of the CU power cable (8).
It is necessary to disconnect power supply of the heating system with thermocontrol from
the AC mains. For the disconnection sequence see the certificate of the power supply unit
of the heating system with thermocontrol.
Keep away the turnstile housing from atmospheric precipitates getting inside the housing
during maintenance.
1. To do maintenance remove the cover with LED indication display (12) from the turnstile
housing in the following way:

unscrew the central bolt of the cover with LED indication display (12), located
beneath the hub (11) with a socket wrench S10; pull the bolt out of the turnstile
housing hole;

remove the cover with LED indication display (12) by lifting the cover by its rear edge
in the LED indication display direction and taking it out of the hooks;

carefully disconnect the indication board cable header from the control device
connector and place the cover with LED indication display on the level steady
surface;

disconnect light indication connector of the heating system with thermocontrol from
the heater controller.
2. Check visually the self-centering mechanism (the pusher, the springs and the roller),
the optical arm rotation sensors and the damper (see Fig. 7).