PERCo TTR-04CW-24, Руководство по сборке и эксплуатации

Страница: 13 / 26

Assembly and Operation Manual
12
6 MARKING AND PACKAGING
The turnstile has the following marking:

on the turnstile housing — a label located inside on the side of the turnstile housing (to
get access to the above label unscrew the fixture bolt close to the lock (10) with a
socket wrench S10 and carefully lift the cover up with the LED indication display (12)).

on the CU — a label located on the back panel of the control unit.
The complete delivery set of the turnstile (Chapter 4.1) is packed in a transportation box to
keep it undamaged during transportation and storage.
7 SAFETY REQUIREMENTS
7.1 Installation safety requirements
The installation should be carried out only by qualified personnel who has taken safety
training and has carefully studied this Manual.
Warning!

Use only the serviceable tools for installation.

Observe general electrical safety rules when laying out the cables.

All the connectors should be connected up when the CU is switched off from the
AC mains.
It is prohibited:
to mount the control unit on the current-conducting surfaces or install it in wet
premises.
See certificates of the power supply units for the safety requirements to those power
supply units
.
7.2 Operation safety requirements
Observe general electrical safety rules when operating the turnstile.
Do not use!

Do not use the turnstile under conditions that do not comply with the
requirements of Chapter 2 of this Manual.

Do not open the CU cover prior to the power supply switching off.

Do not replace the fuses prior to the CU power supply switching off.

The turnstile operates within voltage range from 198V AC to 242V AC only. In
case of jumps in voltage exceeding the operating voltage range, use a voltage
stabilizer.